Introduction
Use our Robotics Board to control an LED with a light dependent resistor.
Video Overview
Featured Document
-
-
Build the circuit as shown in the diagram using the components specified.
-
The light dependent resistor can be inserted into two of the pin sockets on the Female Header component.
-
The standard resistor can be inserted into the Screw Terminal component. (You'll need a small screwdriver to tighten the connectors.)
-
-
-
Upload the Arduino sketch to the Robotics Board.
-
You can find the code here: https://github.com/BrownDogGadgets/Progr...
-
Cancel: I did not complete this guide.
One other person completed this guide.
Attached Documents
