Introduction
Use our Robotics Board to control and RGB LED with three potentiometers.
Video Overview
Featured Document
-
-
Build the circuit as shown in the diagram using the components specified.
-
When connecting the potentiometers, do not cross the tape coming from 5V and GND. (This would create a short circuit.)
-
You can run the GND tape between the LEGO studs (in the gutter) and the 5V tape on top of the LEGO studs so they do not overlap.
-
-
-
Upload the Arduino sketch to the Robotics Board.
-
You can find the code here: https://github.com/BrownDogGadgets/Progr...
-
Cancel: I did not complete this guide.
One other person completed this guide.
Attached Documents
