Introduction
Connect two Pushbuttons to a Bit Board and control a Piezo with code.
We'll explore how we can make sounds using a piezo speaker with two buttons.
Video Overview
Featured Document
-
-
We'll use Maker Tape to connect the two Buttons and the Piezo to the Bit Board on a LEGO baseplate.
-
Connect one Button to Pin 3 and the other Button to Pin 4. Both will also connect to Ground (GND).
-
The Piezo will connect to Pin 8 and to Ground (GND).
-
You'll notice the Ground on the Bit Board (as well as the Piezo, Buttons, and other Crazy Circuits components we'll use) is color coded White.
-
-
-
If you've never used a micro:bit before you'll want to check out this guide: Bit Board V2 Setup and Use
-
We're going to load the following code for our Piezo Loop and Tone program: https://makecode.microbit.org/_Wjz4os6Vb...
-
The micro:bit (since the release of version V2) has included a built-in piezo speaker on the back. You can use the built-in Piezo on a V2 micro:bit or connect a Crazy Circuits Piezo with Maker Tape as we've shown in this guide.
-
The button connected to Pin 3 will start a sound that will loop, and the button on Pin 4 will play a tone (High A) while the button is being pressed.
-
-
-
Once the code is loaded it should start running immediately.
-
You can power the micro:bit via the USB cable you used to load the code or you can use a battery pack plugged into the Bit Board.
-
Try pressing the button connected to Pin 4 a few times. Now press the button connected to Pin 3, then the one on Pin 4 again.
-
-
-
Follow along with our recorded Live Stream!
-
You can watch the full video of us walking through this project, along with explaining and exploring the code: https://www.youtube.com/live/Q4vGpeODS2E...
-
Attached Documents
