Introduction
Program the built-in LED Matrix found on the micro:bit
We'll explore how we can control the LED Matrix to show information and animations.
Video Overview
Featured Document
-
-
For this guide we won't need Maker Tape or any components. We're just going to put the micro:bit into the Bit Board.
-
We're only going to connect a USB cable and use the built-in LED Matrix found on the front of the micro:bit
-
-
-
If you've never used a micro:bit before you'll want to check out this guide: Bit Board V2 Setup and Use
-
We're going to load the following code for our LED Matrix Simple program: https://makecode.microbit.org/_YCfDjyD6q...
-
Our code will just demonstrate a few different basic ways you can use the built-in LED Matrix.
-
We'll see some numbers, icons, and then a letter "A" drawn pixel by pixel.
-
-
-
Once the code is loaded it should start running immediately.
-
You can power the micro:bit via the USB cable you used to load the code or you can use a battery pack plugged into the Bit Board.
-
The micro:bit's built-in LED Matrix will display various things while the code runs.
-
-
-
Follow along with our recorded Live Stream!
-
You can watch the full video of us walking through this project, along with explaining and exploring the code: https://youtube.com/live/3A9rYMbcC04
-
Attached Documents
