Skip to main content

10.4

Major VersionM

by Pete Prodoehl

Introduction

Create a light-up card featuring a Halloween Cat! Just add two LEDs, a CR2032 battery, and some Maker Tape.

There's a full-color version as well as a black & white version that makes a great coloring activity.

You can make this project (and many more!) with our Paper Circuits Kit.

Video Overview

Featured Document

  1. This paper circuits card is a great beginner project. Just follow the steps below to make your card. Print out the full-color card, or print out the black and white card and color/decorate as desired. Poke holes through the front of the card for the LED legs, then push the legs through the front.
    • This paper circuits card is a great beginner project. Just follow the steps below to make your card.

    • Print out the full-color card, or print out the black and white card and color/decorate as desired.

    • Poke holes through the front of the card for the LED legs, then push the legs through the front.

    • Make note of where the positive and negative legs go. Polarity matters!

    • On the inside of the card, bend the LED legs down flat against the paper.

    • Add Maker Tape and a battery to complete your circuit.

    • Note: If you are using thicker paper (such as cardstock) we recommend using a large safety pin to poke the holes in the paper to put the LED legs through.

Finish Line

Attached Documents

Pete Prodoehl

Member since: 03/04/2020

331 Reputation

296 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 1

Past 30 Days: 44

All Time: 317