Skip to main content

10

Minor Versionm

by Joshua

Introduction

Create a fun light-up card for Mother's Day. Just add two LEDs, a CR2032 battery, and some Maker Tape.

Video Overview

Featured Document

  1. In general build this project in this order: Print out the full-color card. Poke holes through front for LED legs, then push legs through front.
    • In general build this project in this order:

    • Print out the full-color card.

    • Poke holes through front for LED legs, then push legs through front.

    • On inside of card, bend legs down flat against paper.

    • Add Maker Tape and battery to complete your circuit.

    • Note: If you are using thicker paper (such as cardstock) we recommend using a large safety pin to poke the holes in the paper to put the LED legs through.

    • We used color cycling LEDs for our Mummy, but you can use white or any color you like!

Conclusion

Enjoy your card!

One other person completed this guide.

Attached Documents

Pete Prodoehl

Member since: 03/04/2020

331 Reputation

279 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 1

Past 30 Days: 5

All Time: 299