Introduction
After building your LEGO Ambulance, follow this step-by-step guide to add an LED circuit with components from your Crazy Circuits Starter Set!
Video Overview
Featured Document
-
-
With the standard build completed, remove the roof to give you easy access to where the add-on modification will go.
-
Gather the extra parts pictured.
-
-
-
Assemble the platform pictured and place the 1x2 brick where shown in photo 1. The 1x2 brick will be needed in order to mount the completed platform into place.
-
Although pictured, wait to insert the platform into the ambulance until the end when you've added the circuitry to it.
-
-
-
Measure, cut, peel and stick tape paths as pictured both here and the attached diagram.
-
Use the second photo and the attached diagram to help you position and press the circuit components into place.
-
Attached Documents
