10.1

Major VersionM

by Pete Prodoehl

LEGO Ambulance Circuit Mod 2

Written By: Andy Wallus (and 2 other contributors)
  • Comments: 0
  • Favorites: 0

Difficulty

Easy

Steps

2

Time Required

00:45:00 - 01:00:00

Sections

1

Flags

0

Introduction

After building your LEGO Ambulance, follow this step-by-step guide to add an LED circuit with components from your Crazy Circuits Starter Set!

Video Overview

Featured Document

  1. Removal of the rear roof lights is the only modification of the standard build needed in order to make room for the circuitry. Removal of the rear roof lights is the only modification of the standard build needed in order to make room for the circuitry.

    • Removal of the rear roof lights is the only modification of the standard build needed in order to make room for the circuitry.

  2. Measure, cut, peel and stick tape paths as pictured both here and the attached diagram. Use the second photo and the attached diagram to help you position and press the circuit components into place.

    • Measure, cut, peel and stick tape paths as pictured both here and the attached diagram.

    • Use the second photo and the attached diagram to help you position and press the circuit components into place.

Finish Line

Author

with 2 other contributors

Andy Wallus

Member since: 10/18/2018

11,442 Reputation

126 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 0

All Time: 107