Skip to main content

10.1

Major VersionM

by Pete Prodoehl

Introduction

After building your LEGO Ambulance Plane, follow this step-by-step guide to add an LED circuit with components from your Crazy Circuits Starter Set!

Video Overview

Featured Document

  1. The only prep required for this circuit mod is to detach the rear hatch from its hinges so that the battery portion of the circuit can be worked on more easily. The only prep required for this circuit mod is to detach the rear hatch from its hinges so that the battery portion of the circuit can be worked on more easily.
    • The only prep required for this circuit mod is to detach the rear hatch from its hinges so that the battery portion of the circuit can be worked on more easily.

  2. Measure, cut, peel and stick tape paths as pictured both here and the attached diagram. NOTE: Use an extra studs-worth of tape for the two paths that lead from the portion of the circuit on top the plane to the hatch so that when the hatch is reconnected at the hinge, the tape doesn't pull out from under the components mounted atop them. Use the third photo and the attached diagram to help you position and press the circuit components into place.
    • Measure, cut, peel and stick tape paths as pictured both here and the attached diagram.

    • NOTE: Use an extra studs-worth of tape for the two paths that lead from the portion of the circuit on top the plane to the hatch so that when the hatch is reconnected at the hinge, the tape doesn't pull out from under the components mounted atop them.

    • Use the third photo and the attached diagram to help you position and press the circuit components into place.

Finish Line

Andy Wallus

Member since: 10/18/2018

11,382 Reputation

122 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 0

All Time: 85