10.1

Major VersionM

by Pete Prodoehl

LEGO Fireboat Circuit Mod

Written By: Andy Wallus (and 2 other contributors)
  • Comments: 0
  • Favorites: 0

Difficulty

Easy

Steps

3

Time Required

00:45:00 - 01:00:00

Sections

1

Flags

0

Introduction

After building your LEGO Fireboat, follow this step-by-step guide to add an LED circuit with components from your Crazy Circuits Starter Set!

Video Overview

Featured Document

  1. Remove the parts shown to make room for a new platform that your circuit will be mounted on. Remove the parts shown to make room for a new platform that your circuit will be mounted on.

    • Remove the parts shown to make room for a new platform that your circuit will be mounted on.

  2. Use the parts pictured to modify your completed build by adding a platform for your circuit. Use the parts pictured to modify your completed build by adding a platform for your circuit.

    • Use the parts pictured to modify your completed build by adding a platform for your circuit.

  3. Measure, cut, peel and stick tape paths as pictured both here and the attached diagram. Use the second photo and the attached diagram to help you position and press the circuit components into place.

    • Measure, cut, peel and stick tape paths as pictured both here and the attached diagram.

    • Use the second photo and the attached diagram to help you position and press the circuit components into place.

Finish Line

Author

with 2 other contributors

Andy Wallus

Member since: 10/18/2018

11,382 Reputation

122 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 0

All Time: 55