Skip to main content

10.1

Major VersionM

by Pete Prodoehl

Introduction

After building your LEGO Firetruck, follow this step-by-step guide to add an LED circuit with components from your Crazy Circuits Starter Set!

Video Overview

Featured Document

  1. Remove the flat plate behind the roof lights on the truck to make room for a studded plate of the same size. Remove the flat plate behind the roof lights on the truck to make room for a studded plate of the same size.
    • Remove the flat plate behind the roof lights on the truck to make room for a studded plate of the same size.

  2. Gather the plate pictured and press it into place where the flat plate was. This will create enough studded area for you to add the circuitry. Gather the plate pictured and press it into place where the flat plate was. This will create enough studded area for you to add the circuitry.
    • Gather the plate pictured and press it into place where the flat plate was. This will create enough studded area for you to add the circuitry.

  3. Measure, cut, peel and stick tape paths as pictured both here and the attached diagram. Use the second photo and the attached diagram to help you position and press the circuit components into place.
    • Measure, cut, peel and stick tape paths as pictured both here and the attached diagram.

    • Use the second photo and the attached diagram to help you position and press the circuit components into place.

Finish Line

Andy Wallus

Member since: 10/18/2018

11,176 Reputation

121 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 1

Past 30 Days: 2

All Time: 51