Introduction
This is the basic Robot Buddy body template. Decorate your buddy, cut it out, and then add LEDs and/or a motor. Check out our other guides for more outfits and 'skins' for your buddy. For best results print off the Robot Buddies template on card stock.
Featured Document
-
-
Use a safety pin to punch out the holes for the LED legs.
-
Cut your buddy out, then color it, and lastly tape or glue it together.
-
You should really only need two small pieces of clear tape. Start with the battery flap, then tape the two 'sides' to the bottom of it. Lastly fold the other big flap and use a piece of tape to secure.
-
Use a ruler or other straight edge to help you fold the various dotted lines.
-
Almost done!
Finish Line
Attached Documents
