Introduction
The king of the lizards was a fearsome creature millions of years ago. These days the mighty T-Rex just looks cute when you make it out of colorful paper.
Tools
Parts
Video Overview
Featured Document
-
-
Print off the template, trace it, and cut out your T-Rex body parts.
-
If you plan on freehand cutting your body, be sure to read all the directions first. Pay special attention to how we create the battery holder.
-
-
-
Bend both LED legs 90 degrees.
-
Stick the long positive leg through the paper. It may help to cut a small slit in the paper.
-
-
-
Run a piece of tape along the front of your T-Rex, covering the negative LED leg.
-
-
-
Run a piece of tape covering the positive LED leg, down and then over to the round battery holder piece.
-
The tape should wrap around the round part to the front side of the T-Rex.
-
-
-
Place the battery so that bottom (negative) side is over the negative line of tape.
-
Fold down the round battery holder section on the back so that the positive line of tape make contact with the top of the battery.
-
The LED should turn on!
-
-
-
Use a binder clip to hold the battery in place.
-
To "Turn Off" the project, just remove the binder clip.
-
-
-
Add on the rest of the body parts using glue or tape.
-
Your Dino Friend is now complete... Enjoy!
-
-
-
Since Maker Tape is conductive on both sides you can use it to make a tape loop that helps hold your battery in place.
-
If you wanted to, you could use two tape loops (one for each side of the battery) and turn on and off your circuit without the need of a binder clip.
-
-
-
Check out our other Dino Friends; Triceratops, Pterodactyl, and Plesiosaurus.
-
Cancel: I did not complete this guide.
One other person completed this guide.
Attached Documents
