Introduction
Create your own light up Mother's Day card using an LED, battery, and conductive tape. This card features an adorable Baby Yoda, only takes minutes to make, and is activated by a paper switch.
Parts
Featured Document
-
-
In general build this project in this order: Color or decorate your card, poke LED legs through the paper, add tape and battery, and you're all set!
-
Note: If you are using thicker paper (such as cardstock) we recommend using a large safety pin to poke the holes in the paper to put the LED legs through.
-
Cancel: I did not complete this guide.
One other person completed this guide.
Attached Documents
