Introduction
A set of 3D printed stackable bins for small parts.
Tools
Parts
No parts specified.
-
-
You can download the file and print it on your own 3D Printer.
-
Find it in our GitHub repository: https://github.com/BrownDogGadgets/3D-Pr...
-
There are four different versions depending on the height you want your bin.
-
-
-
If you print as a one-color print you can ignore the "Paw" file, but if you want to do a two color print (and you have a multicolor printer) you can load the Bin and Paw together in your slicer and then choose two different colors.
-
We recommend a darker color for the Paw. Black works best. If you print with an 0.2 layer height it will use just a single layer for black and reduce waste due to filament changes.
-
-
-
Great for LEDs and other small parts.
-
And they are stackable to conserve space!
-
Reminder: Do not put CR2032 batteries into a container! It's best to store them in our CR2032 Battery Holders so they do not short out!
-
-
-
Add some rubber feet to the bottom if you want them to be non-slip on your desk.
-
They still stack just fine with feet attached.
-
-
-
If these bins look familiar, you may have seen Gridfinity, a modular, open-source grid storage system!
-
We originally wrote our own code, but then realized it closely matched up with a 4x4 Gridfinity bin.
-
So we ended up using code from Gridfinity Rebuilt, an OpenSCAD library for Gridfinity in our design.
-
The size is also perfect for 3" square sticky notes. :)
-