Skip to main content

1.2

Major VersionM

by Pete Prodoehl

Introduction

A 3D Printed LEGO Technic Compatible mount for a Distance Sensor. This is used in the Bit Board Rover Kit. We are sharing the file in case you want to print your own.

Parts

No parts specified.

  1. You can download the file and print it on your own 3D Printer.
  2. The Distance Sensor slides into the holder and is held in place by gravity. Every 3D printer is a little different! If your part doesn't fit properly here are a few things to try. Part too tight? Try sanding it or cutting away some material with a knife.
    • The Distance Sensor slides into the holder and is held in place by gravity.

    • Every 3D printer is a little different! If your part doesn't fit properly here are a few things to try.

    • Part too tight? Try sanding it or cutting away some material with a knife.

    • Part too loose? Try adding tape as a shim.

    • You can also try printing it at slightly more or less than 100% scale.

Finish Line

Pete Prodoehl

Member since: 03/04/2020

331 Reputation

287 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 4

Past 7 Days: 9

Past 30 Days: 21

All Time: 171