Skip to main content

10.1

Major VersionM

by Pete Prodoehl

Introduction

After building your LEGO Prisoner Transport Van, follow this step-by-step guide to add an LED circuit with components from your Crazy Circuits Starter Set!

Video Overview

Featured Document

  1. Removal of the parts pictured is the only modification required on the standard completed build. This will create the needed area for your circuit. Removal of the parts pictured is the only modification required on the standard completed build. This will create the needed area for your circuit.
    • Removal of the parts pictured is the only modification required on the standard completed build. This will create the needed area for your circuit.

  2. Measure, cut, peel and stick tape paths as pictured both here and the attached diagram. Use the second photo and the attached diagram to help you position and press the circuit components into place.
    • Measure, cut, peel and stick tape paths as pictured both here and the attached diagram.

    • Use the second photo and the attached diagram to help you position and press the circuit components into place.

Finish Line

Andy Wallus

Member since: 10/18/2018

11,442 Reputation

126 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 0

All Time: 145