Skip to main content

1.1

Major VersionM

by Pete Prodoehl

Introduction

The Pin Pliers can be used to pull out a difficult to remove LEGO Technic Pin.

It prints in three parts and then the small clip holds the two halves of the pliers together.

We modified Anachronist's Over-engineered JST connector pliers by changing the front part to be compatible with the LEGO Technic Pin.

Parts

No parts specified.

  1. You can download the file and print it on your own 3D Printer.
  2. We recommend printing with three outer shells and a good amount of infill (25% should work) to make these pliers strong.
    • We recommend printing with three outer shells and a good amount of infill (25% should work) to make these pliers strong.

    • Every 3D printer is a little different! If your part doesn't fit properly here are a few things to try.

    • Part too tight? Try sanding it or cutting away some material with a knife.

    • Part too loose? Add a piece of paper or tape as a shim.

    • You can also try printing it at slightly more or less than 100% scale.

Finish Line

Pete Prodoehl

Member since: 03/04/2020

340 Reputation

298 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 3

Past 30 Days: 8

All Time: 590