Introduction
A 3D Printed LEGO Compatible mount for a Thumbstick Sensor.
Tools
Parts
No parts specified.
-
-
You can download the file and print it on your own 3D Printer.
-
Find it in our GitHub repository: https://github.com/BrownDogGadgets/3D-Pr...
-
This file will work with our Thumbstick Sensor.
-
-
-
The Thumbstick Sensor slides into the holder and is held in place by friction. If the fit is a bit too tight you can file or sand the inside holding arms of the print.
-
Part too tight? Try sanding it or cutting away some material with a knife.
-
Part too loose? Add two LEGO bricks on opposite sides of the part.
-
You can also try printing it at slightly more or less than 100% scale.
-
Cancel: I did not complete this guide.
One other person completed this guide.