Skip to main content

1.0

Major VersionM

by Pete Prodoehl

Introduction

Use these easy to make Paper Circuits Cubes to demonstrate the basics of circuitry. Learn about open and closed circuits, polarity, power and components.

Besides our Paper Circuits Kit (which contains Maker Tape, batteries, and LEDs) you'll need a few magnets, washers, and tape.

Featured Document

  1. If you haven't built any cubes yet make sure to check out the guide for Paper Circuits Cubes first. Use this cube as an on/off switch between a power cube and output cube, such as an LED. This is the same switch from our Switch - Lever Switch guide.
    • If you haven't built any cubes yet make sure to check out the guide for Paper Circuits Cubes first.

    • Use this cube as an on/off switch between a power cube and output cube, such as an LED.

    • This is the same switch from our Switch - Lever Switch guide.

    • Reminder: Assemble the cube before you apply the Maker Tape as it needs to wrap around multiple sides of the completed cube.

  2. With the Lever Switch Cube you can control when your circuit is providing power. Just add the Level Switch Cube between your power source and any component that needs power to operate. Just add the Level Switch Cube between your power source and any component that needs power to operate.
    • With the Lever Switch Cube you can control when your circuit is providing power.

    • Just add the Level Switch Cube between your power source and any component that needs power to operate.

Finish Line

Attached Documents

Pete Prodoehl

Member since: 03/04/2020

331 Reputation

286 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 7

Past 7 Days: 16

Past 30 Days: 116

All Time: 285