Introduction
A 3D Printed Tape Roll Holder for Maker Tape.
Tools
Parts
No parts specified.
-
-
You can download the files and print them on your own 3D Printer.
-
Find the files in our GitHub repository: https://github.com/BrownDogGadgets/3D-Pr...
-
You can also find the files on Printables and Thingiverse.
-
We have files will work with the 20m and 5m rolls of 1/4" wide Maker Tape and the 5m rolls of our 1/8" wide Maker Tape.
-
-
-
We've made some improvements to the Large version by simplifying the design. There is now the main body of the holder and four separate clips that snap into place.
-
Get the 1/4" holder here: https://github.com/BrownDogGadgets/3D-Pr...
-
-
-
We also created a version for the small (5m) rolls of our 1/8" Maker Tape.
-
Get the 1/8" version here: https://github.com/BrownDogGadgets/3D-Pr...
-
-
-
Is the peg too tight? You can try to sand it down a little. You want a snug fit but not so tight it cannot freely pivot after inserted.
-
You can also try printing it at slightly more or less than 100% scale if the fit isn't quite right.
-
Cancel: I did not complete this guide.
One other person completed this guide.